- Home
-
Masks, Fins
We recommend:xDeep RADICALzł260.00Tusa PARAGON optical "-"zł699.00EX1 - JET finszł399.00LightJet - lightweight finszł518.54
-
Regulators
We recommend:xFROG ST2W +OCTO +SPGzł1,850.00xFROG ST4E +OCTO +SPGzł3,200.00xFROG - ST4 HD Silver BackMountzł3,400.00xFROG - ST4 HD Black SideMountzł4,800.00
- BCD Wings
- Gauges
- Suits
- Accessories
- Service
custom html
We ship worldwide
Shipping within 48 hours
We have a loyalty program
We care about the safety of shipments
The wrench is used to easily and quickly apply o-rings to the pressure gauge connector.
Parameters:
- base made of derlin,
- needle - a rod with a diameter of 0.8 mm.
In order to apply the orings it is necessary to:
1. prepare the connector, orings and needle.
2. the fastener is placed in the hole located in the black base of the needle (fig.1)
3. the side of the connector on which you want to put the oring should be on top - sticking out from the base (fig.2).
3. put the o-ring on the needle, and then insert it into the hole located in the connector (fig.3).
4. move the oring downward until it is placed on the connector (fig.4).
No reviews
Comments (0)
No customer reviews for the moment.
Your review appreciation cannot be sent
Report comment
Are you sure that you want to report this comment?
Report sent
Your report has been submitted and will be considered by a moderator.
Your report cannot be sent
Write your review
Review sent
Your comment has been submitted and will be available once approved by a moderator.